# set network ike gateway NewYork VPN protocol ikev1 dpd enable no # set network virtual-router "Virtual Router 1" interface # set network interface tunnel units tunnel.10 comment "NewYork VPN" # set network interface tunnel units tunnel.10 ipv6 interface-id EUI-64 # set network interface tunnel units tunnel.10 ipv6 enabled no The commands below should be executed in the order listed. The following information is used as example data for the commands. Note: For the commands listed in this document, it is recommended to use the same IKE and IPSec cryptos for the new IPSec tunnels. Before running the commands, ensure that the IKE and IPSec crypto profiles are configured on the firewall. This document provides the CLI commands to create an IPSec VPN, including the tunnel and route configuration, on a Palo Alto Networks firewall.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |